Ricoh D015 - Manual (Page 10)

Product Support Guide
D014 / D015
Ver.1.9 Page 10 of 38 1/16/2009
Subject to change without notice
# Slot Option Name
1 A Copy Connector (B328) only
2 B
• IEEE1284 (B679) • File Format Converter (D377) • IEEE802.11a/g (D377)
• Bluetooth (B826)
3 C
Gigabit Ethernet (D377). The EFI (Fiery) controller is connected through
Gigabit Ethernet.
4 Upper
• Browser Unit (D377) • Data Overwrite Security (D377) • HDD Encryption Unit (D377)
• PostScript3 (D378) • Printer/Scanner Unit (D376)
5 Lower
• VM Card (D377)
Also used as the Service Slot for firmware updates, moving applications to another SD card
with SP5873 (Apli Move).
6 USB 2.0 Built-in for connection of USB devices.
7 100BaseT Standard LAN connection point.
8
9
USB Ch1
USB Ch 2
For future use (PictaBridge, other application devices).
Note: These connection points are covered with a plate. Remove the
screw, rotate the plate and reattach it with the screw so that the slots
are exposed, and then attach the connector.
10 TEL Jack for telephone connection
11 Line 1
Jack for main telephone line from the outside for connection to Fax
Option (D356).
12 ISDN Jack for ISDN connection Japan Only
13 Line 2
Jack for a 2nd line connection to Fax Interface Unit (D357) (G3) when
this option is installed.
14 Line 3 Not used. (G4 is not available for installation outside Japan at this time.)
Important Notes
• Only two SD Card slots are available for applications.
• The VM card must be inserted in the lower slot.
• Other applications must be inserted in the upper slot.
• If more than one application is required in the upper slot, the applications must be
moved to the same SD card with SP5873-1.
• The PostScript3 application cannot be moved to another card. However, other
applications can be moved to the PostScript3 SD card.
• The VM Card must be inserted in the lower slot. This is because it requires about 22 MB
of disk space, and cannot be merged onto the SD card in the upper slot if that card
already contains all the other applications.
• If the customer needs more than one application in the upper slot, the applications must
be moved to one SD card. (See "Moving Applications to One SD Card" in this section)