beautypg.com

7 introduction, If the stand is uneven, When moving the instrument – Roland F-100 User Manual

Page 7: When disassembling, When changing the orientation of the speaker box

background image

7

Introduction

4.

Tighten the screws on the side panels to secure
that side panel the F-100 and speaker box (four
locations).

fig.st03-2

5.

Stand the instrument back up.

When lifting the instrument back up, grasp near the
center of the speaker box and the F-100, and gently raise
the instrument.

fig.st03-2

If the Stand is Uneven

If after lifting the F-100 back up you find that stand is
crooked, try loosening the screws and then securing
them again. When retightening, start with the top
screws, then work your way down. When doing this,
slightly loosen the screws before firmly tightening them.

To stabilize the pedals

Temporarily loosen the screws that fasten the pedal
board.

Step on the pedal, and after verifying that the pedal is in
firm contact with the floor, re-tighten the screws firmly.

6.

Place the caps over the heads of the screws (five
on each side).

fig.st03

7.

Connect the speaker cable extending from the
rear of the speaker box to the F-100’s speaker
connector.

Press the speaker cable completely into the connector so
that it is securely fastened.

fig.st04

8.

Connect the pedal cables to the Pedal [Damper]
jack and [Soft] jack.

Connect the brown plug to the Damper jack, and the
black plug to the Soft jack.

9.

As necessary, affix cord cramps as shown in the
diagram to fasten the pedal cable.

fig.st04

When Moving the Instrument

Disconnect the AC cord, cables, the music stand and the lid
from the F-100.

Then lift the piano while keeping it level, and move it with
care, so that you do not drop it on your feet, or get your
hands caught.

Check the stability of the pedal, and make adjustments as
necessary.

When Disassembling

Disassemble the unit by carrying out assembly Steps 1-8 in
reverse order.

When Changing the Orientation of the
Speaker Box

Be sure to completely disassemble the unit, change the
speaker box orientation, then reassemble it.

Screws

Caps

F-100 Rear

Hold and insert the cable so that

the clip portion extends into the

stand and is securely connected.

Speaker cable

Speaker Connecter

Clip Portion

Cord Cramps

Pedal Cord

F-100.e.book 7 ページ 2003年8月29日 金曜日 午前9時48分