Assembling the lid, Installing the lid holders – Roland F-100 User Manual
Page 11
11
Before You Play
Assembling the Lid
NOTE
You must always use both hands to open or close the lid.
When opening and closing the lid, be very careful not to
catch your finger in the lid.
1.
Attach the included lid as shown in the diagram.
fig.00-04
2.
When opening the lid, grasp the lid with your
hands and gently lift it upwards.
3.
When closing the lid, grasp the lid with your
hands and gently lower it down.
NOTE
Make sure an adult is on hand to provide assistance when
young children are playing the F-100.
NOTE
When you move the piano, be sure to remove the lid to
prevent accidents. Be careful not to drop the removed lid.
■
Installing the Lid Holders
Attaching the supplied lid holders provides you with a place
to rest the lid whenever it's been removed.
Check the Parts
Installation Procedure
1.
1.
Remove the four screws from both sides of the
rear panel of the F-100.
* Be careful not to lose the screws you've removed. You will
need to put them back in place at the rear of the F-100 if you
decide that you don't want to use the lid holders.
2.
Attach the lid holders to the rear panel of the F-
100 using the supplied attachment screws (four
locations).
Placing the Lid
Rest the lid on the lid holders gently, as shown.
NOTE
Never lean against, nor apply excessive force to the lid while
it is resting on the lid holders.
Lid
Keyboard
Projection
Lid Holders (left and right)
Attachment screws (4)
Remove the screws at both ends
Attachment
screws
Lid Holder
Lid
Lid Holder
Align the ends of
the lid with the
corners of the lid holders
F-100.e.book 11 ページ 2003年8月29日 金曜日 午前9時48分