beautypg.com

Assembling the f-100, Check the parts, Assembly procedure – Roland F-100 User Manual

Page 6: 6 introduction

background image

6

Introduction

Assembling the F-100

Make sure that another person is on hand to help with the assembly and setup.

To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you assemble and

move the piano, to make sure that you do not drop it on your hands or feet.

Always carry out this procedure with the F-100 lying horizontally, with the rear panel facing down.

Check the Parts

Before you begin assembling the F-100, check that all the
parts were supplied.

You will also need to have a Phillips screwdriver.

fig.st1

The speaker box can also be installed so that it faces toward
the rear instead of toward the front. Having the speaker box
face out the rear of the instrument allows the speakers to be
directed toward listeners when the back of the instrument
faces the audience.

fig.stsp

Assembly Procedure

• At first, assemble the entire unit in a temporary fashion,

without really tightening the screws.
Then, after checking the overall alignment of the boards
(and gently shifting certain parts where necessary), go
around and tightly fasten each of the screws.

• Be careful when assembling the F-100, so as to avoid

scratching the side panels.

When securing the screws, lay the entire unit sideways
with the rear side of the F-100 at the bottom.

1.

Tighten the screws on one of the side panels to
secure that side panel the F-100 and speaker box
(four locations).

Install so that the speaker cable at the rear of the speaker
box extends to the right side (the side where the F-100’s
[Power] switch is located).

fig.st02-2

2.

Align the projection of the pedal board with the
hole in the side panel, and use a screw to fasten
the pedal board (one location).

fig.st02-2

3.

Align the hole in the other side panel with the
projection of the pedal board, and use a screw to
fasten the pedal board (one location).

fig.st02-2

Front

1

F-100

2

3

4

Pedal Board

5

6

Speaker box

Speaker cable

Side panel right and left

(Left)

(Right)

Front

Rear

Rear

Cross section

Screw x 10

Cap x 10

(and some spare caps)

Normal direction

When facing to the rear

Front

Rear

Front

Rear

Speaker

box

Speaker
box

F-100

Side with
rounded
corners
facing out

Speaker box

Side panel

(Right)

Screws

Pedal Board

Screw

Side with
rounded
corners
facing out

Side panel
(Left)

Screw

F-100.e.book 6 ページ 2003年8月29日 金曜日 午前9時48分