Radio Shack TAD-1004 - Manual (Page 8)

8
Note: Be sure the keyhole slots on
the bracket and the TAD are
pointed in the same direction.
4. Align the wall plate’s two studs with
the keyhole slots on the bottom of
the TAD. Slide the TAD down onto
the studs to secure the TAD to the
wall plate.
5. Slide the handset clip up and out of
its retaining slot in the base. Rotate
the clip so the tab points up, then
slide the clip back into its slot.
Hang the handset on the base.
Directly on a Wall
1. Drill two holes 3 15 /
16
inches (100
mm) apart.
2. Thread a screw (not supplied) into
each hole until the head extends
only about
3 /
16
of an inch (5mm)
from the wall.
3. Snap the supplied mounting
bracket into the slots on the bottom
of the TAD.
Note: Be sure the keyhole slots on
the bracket and the TAD are
pointed in the same direction.
4. Align the two screws with the key-
hole slots on the bottom of the
TAD. Slide the TAD down onto the
screws to secure the TAD to the
wall.
43-744.fm Page 8 Friday, August 13, 1999 2:10 PM