Radio Shack TAD-1004 User Manual
Page 18
18
Before playing each message, the TAD
announces the message number and
the day and time when each message
was recorded. After all messages play,
the TAD says, “End of message(s)” and
saves all the messages.
Repeating Messages
To review a message while you are lis-
tening to it, press
REPEAT/CODE
. The
current message starts again from the
beginning.
To hear the previous message, press
and hold down
REPEAT/CODE
until that
message’s number appears. The TAD
plays the message. To hear an earlier
message, repeat the procedure until the
desired message’s number appears.
Skipping Messages
To skip to the next message while you
are listening to a message, press
SKIP/
MEMO
once. The next recorded mes-
sage plays.
Pausing Message Playback
To pause a message, press
PLAY/
STOP
.
PA
appears on the display. Wait
at least 2 seconds, then press
PLAY/
STOP
again to resume playing messag-
es.
Note: If you do not resume playing mes-
sages within 60 seconds, the TAD
sounds a beep, displays the total num-
ber of messages, stops playback, and
resets to answer calls.
43-744.fm Page 18 Friday, August 13, 1999 2:10 PM