Radio Shack TAD-1004 - Manual (Page 13)

13
USING PRIVACY
If you want to speak with someone in
the room without the person on the
phone hearing your conversation, press
and hold
PRIVACY . Release PRIVACY to
resume your phone conversation.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Set PULSE/TONE to PULSE .
2. Call the service.
3. When the service answers, set
PULSE/TONE to TONE .
4. Follow the normal procedure for
the service you are using. Any
additional numbers dialed are sent
as tone signals.
5. When you complete the call, set
PULSE/TONE back to PULSE and
hang up.
MEMORY DIALING
You can store emergency phone num-
bers or the phone numbers you most
frequently call in the three priority mem-
ory locations for one-touch dialing. You
can store 10 more phone numbers in
the indirect memory locations, then
quickly call the number by entering its
memory location number. Each memo-
ry location can store up to 16 pulse dig-
its or 15 tone digits.
Storing Numbers in Memory
1. Pick up the handset.
2. Press STORE . You can still hear a
dial tone from the handset.
3. Enter the phone number you want
to store.
Notes:
• The phone does not actually dial
the number.
• If you make a mistake, press and
hold down the switchhook for a
few seconds. Then release the
switchhook and begin again
from Step 2.
43-744.fm Page 13 Friday, August 13, 1999 2:10 PM