Radio Shack TAD-1004 - Manual (Page 7)

7
Follow these steps to install the battery.
1. Use a flat-bladed screwdriver to
push the latch on the battery com-
partment cover, then lift the cover.
2. Snap the battery’s terminals to the
connector inside the compartment.
3. Replace the cover and press down
on the latch to close it securely.
When the battery is low and needs re-
placing,
Lo and 00 alternately flash on
the display. Be sure the AC adapter’s
cord is plugged in while you replace the
battery, so you do not lose the TAD’s
stored information.
USING RESET
If the TAD does not work, press RESET
on the back of the TAD to reset the an-
swering machine.
Note: The outgoing message and all in-
formation stored in memory are erased
when you press
RESET .
WALL MOUNTING
You can mount the TAD on a standard
wall plate or directly on the wall, using
two screws with heads that fit into the
keyhole slots on the back of your TAD.
On a Wall Plate
1. Plug one end of the supplied short
modular cord into the jack on the
back of the TAD.
2. Plug the other end of the modular
cord into the wall plate jack.
3. Snap the supplied mounting
bracket into the slots on the bottom
of the TAD.
43-744.fm Page 7 Friday, August 13, 1999 2:10 PM