Radio Shack ET-908 - Manual (Page 8)

8
4. Press the AC cord into the top and
bottom grooves on the left side of
the bracket, press the modular
cord into the center groove on the
right side of the bracket, then plug
the modular cord into the modular
phone jack.
5. Line up the keyhole slots on the
bracket with the studs on the wall
plate, then slide the base down
onto the wall plate until it is
secure.
6. Press up on the handset holder to
remove it, turn it over so its tabbed
edge faces up, then press it back
down into its slot on the base.
7. Plug the ET-908’s AC cord into a
standard AC outlet. The POWER
indicator turns on.
8. For the best reception, adjust the
base’s antenna so it stands
straight up.
Note: If you want to remove the sup-
plied bracket after attaching it, simply
press in the tab on each side of the
bracket and lift the bracket away from
the base.
POWER
CORDLESS • SPEAKERPHONE ET-908
T ONE
PULSE
43-1083.fm Page 8 Tuesday, August 17, 1999 2:17 PM