Radio Shack ET-908 - Manual (Page 15)

15
OPERATION
Important: If you move the handset
outside the base’s range, the handset
will not operate properly and a call in
progress might be disconnected (see
“Troubleshooting” on Page 21).
MAKING/ANSWERING
CALLS
To make a call, simply lift the handset
and press
TALK . When you hear the
dial tone, dial the desired phone num-
ber or memory number (see “Using
Memory Dialing” on Page 18).
To answer a call if the handset is on
the base, simply lift the handset and
begin your conversation.
To answer a call if the handset is not
on the base, press any key on the
handset except
OFF before speaking.
Notes:
• Both the IN USE indicator on the
base and the TALK indicator on
the handset flash when you
receive a call, and light steadily
while the handset is in use.
• If the handset’s ringer is turned on
and you press OFF while the
handset is ringing, the handset’s
ringer turns off for that call only,
then it automatically turns on
about 5 seconds after the call
ends.
• To turn the handset’s volume up
or down during a call, press or
on the side of the handset.
To end a call, place the handset on the
base or press
OFF . The IN USE indica-
tor on the base and the TALK indicator
on the handset turn off.
TALK CH OFF
PRIVACY / LOW BATT
1 2 3
ABC DEF
TALK
MEMORY DIALING
•
•
•
•
• •
•
•
•
• CHARGE
IN USE
PAGE
POWER
PAGE
TALK CH OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
43-1083.fm Page 15 Tuesday, August 17, 1999 2:17 PM