Radio Shack ET-908 - Manual (Page 18)

18
CHANGING CHANNELS
The ET-908 continuously scans 10
channels (frequency pairs used be-
tween the base and the handset) and
automatically selects the one with the
least interference each time you make
or receive a call.
If you notice interference during a call,
however, you can repeatedly press
CH
(channel) to try and find a clearer
channel. The ET-908 changes to a dif-
ferent channel each time you press
the key.
Note: You cannot change the channel
while using
HOLD .
USING MEMORY
DIALING
You can store up to 10 numbers in the
ET-908’s memory, then dial them at
the press of a few buttons.
Note: Each phone number can be up
to 16 digits long.
Storing a Number in Memory
Note: You must complete Steps 1-3
within 30 seconds of each other. If you
do not, the ET-908 sounds a long
beep, all indicators stop flashing, and
you must start over again at Step 1.
1. Press PROG . The TALK indicator
flashes.
2. Press the number key ( 0 - 9 ) of the
memory location where you want
to store the phone number.
3. Enter the phone number you want
to store (up to 16 digits).
Notes:
• To store the last number you
dialed, you can simply press
REDIAL .
• You can store special banking
or telephone service numbers
(such as access codes or
account numbers) in memory.
TALK CH OFF
PRIVACY / LOW BATT
1 2 3 ABC DEF CH
43-1083.fm Page 18 Tuesday, August 17, 1999 2:17 PM