Radio Shack ET-908 - Manual (Page 13)

13
SETTING THE PULSE/
TONE SWITCH
Set PULSE/TONE for the type of service
you have. If you are not sure which
type you have, do this test.
1. Set PULSE/TONE to TONE .
2. Press TALK on the handset and
listen for a dial tone. The indicator
above
TALK turns on.
3. Press any number other than 0 .
If the dial tone stops, you have
touch tone service. Leave
PULSE/
TONE set to TONE .
If the tone continues, you have
pulse service. Set
PULSE/TONE to
PULSE .
4. To hang up, either place the hand-
set on the base or press OFF on
the handset.
ADJUSTING THE
RINGER
Checking/Setting the Ringer
Type
The ET-908 is preset to use ringer type
1. To check or change the ringer type,
follow these steps.
1. Press PROG . The indicator above
TALK flashes.
2. Within 30 seconds, press # , then
press 1 - 4 (one key after the other)
to hear the different ringer types.
The ET-908 sounds a different
ringer type for each key.
Notes:
• To hear the currently selected
ringer type, press 0 anytime
after you press # during this
step.
• If the indicator above TALK
turns off before you make your
selection, press
PROG again
then repeat this step.
3. When you hear the ringer type
you want to use, press # to select
it. The indicator turns off.
TONE PULSE
TALK CH OFF
PRIVACY / LOW BATT
1 2 3
ABC DEF
TALK
TALK CH OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
PROG
43-1083.fm Page 13 Tuesday, August 17, 1999 2:17 PM