Radio Shack 2.4 GHz 2-Line Digital Spread Spectrum Cordless Phone with Call Waiting/Caller ID - Manual (Page 20)

20 Basic Operation
Note: The paging ends in one minute if no-
body answers. Press
INTERCOM or
8 8 8 8
/ IN-
TCM again.
To end an intercom call, press
8 8 8 8
/ INTCM or
INTERCOM .
During a call, you can page someone at ei-
ther the base or the handset to join the con-
versation. Press
INTERCOM or
8 8 8 8
/ INTCM .
The current call is placed on hold.
To transfer the call, press INTERCOM or
8 8 8 8
/
INTCM again when the person at the base or
handset answers.
To start a 3-way call, tell the person at the
base or handset to press the line button for
the call, then press the same button twice on
your keypad when they answer the page.
Notes:
• You cannot page the base or handset if
it is already in use.
• If a call comes in during an intercom
conversation, either of the intercom par-
ties can answer the call as they normally
would. Simply press the ringing line’s
button. The intercom call automatically
disconnects.
USING A HEADSET
You can talk with hands-free convenience
using an optional headset that has a
3 / 32 -inch
(2.5-mm) plug. Contact your local Ra-
dioShack store for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset, then insert
the headset’s plug into the jack.
Notes:
• Connecting a headset disconnects the
handset’s earpiece and microphone, but
it does not affect the phone’s speaker-
phone.
• DEL / VOL on the handset also controls
the connected headset’s volume.
• If you place the handset on the base to
recharge it while the headset is con-
nected, be sure the handset seats prop-
erly.
With a headset connected, you make or an-
swer calls as usual using the keys on the
handset.
You can use a handset holder (available
from your local RadioShack store) to hang
the handset on your belt for greater conve-
nience. When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.