Radio Shack 2.4 GHz 2-Line Digital Spread Spectrum Cordless Phone with Call Waiting/Caller ID - Manual (Page 15)

15 Installation
3. A menu appears with
7kje 7kje 7kje 7kje JWba JWba JWba JWba
selected.
Press CONF /
9 9 9 9
to select
9?:9M 9?:9M 9?:9M 9?:9M
, then
press SELECT / CH to change the setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears indicating the selected
setting.
4. Press CID / HOLD and return the handset
to the base to store the new setting.
STORING YOUR AREA
CODE
You can store your local area code in the
phone’s Caller ID record so it does not show
the area code if the received call is from your
local area. If for some reason you need to
dial the area code (or store it in memory),
you can add it afterwards. See “Adding/De-
leting the Area Code” on Page 25.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code but leave this option blank.
Follow these steps to store your area code.
1. Lift the handset and hold down CID /
HOLD until
9Wbb[h 9Wbb[h 9Wbb[h 9Wbb[h ?: ?:?: ?: I[jkf I[jkf I[jkf I[jkf
appears on the
display with
B_d[ B_d[ B_d[ B_d[ ''''
selected.
2. Use
∗∗∗∗
/ TONE /
6 6 6 6
or # /
7 7 7 7
to select
B_d[ B_d[ B_d[ B_d[ ''''
or
B_d[ B_d[ B_d[ B_d[ ((((
. Then press CONF /
9 9 9 9
.
3. A menu appears with
7kje 7kje 7kje 7kje JWba JWba JWba JWba
selected.
Press CONF /
9 9 9 9
twice to select
7h[W 7h[W 7h[W 7h[W 9eZ[ 9eZ[ 9eZ[ 9eZ[
,
then press SELECT / CH .
4. Enter your three-digit area code. If you
make a mistake, repeatedly press
∗∗∗∗
/
TONE /
6 6 6 6
or # /
7 7 7 7
to move the cursor
over the incorrect digit, then enter the
correct number.
Note: If an area code is already stored,
it appears on the display. To delete the
area code, press
DEL / VOL three times,
then enter your area code. Or you can
use
∗∗∗∗
/ TONE /
6 6 6 6
or # /
7 7 7 7
to move the cur-
sor and edit the area code.
5. Press SELECT / CH to store the area
code, then press CID / HOLD and return
the handset to the base to store your
new entry.