RCA VR355/VR545 - Manual (Page 23)

Chapter 2 21
Using On-Screen Menus
Remote VCR1/VCR2 Option
Some universal remote controls have buttons labeled VCR1 and VCR2. These remotes can operate
up to two VCRs. If you have a universal remote control with this ability, your RCA VCR can be
controlled with either the VCR1 or VCR2 button. See the documentation that came with your
universal remote control for details about programming it to control your RCA VCR.
In the Preferences menu, press 1 to select the Remote Control feature. Then press the VCR2 button
on your universal remote control to change the setting.
The VCR will only respond to the universal remote control’s VCR2 button. To change the remote
control setting back to VCR1, display the PREFERENCES menu, press 1, and then press the VCR1
button on the universal remote control.
Note: Remember you must press VCR1 or VCR2 on a universal remote control (not included)
—whichever is selected in the menu—before the remote will operate the VCR.
Auto Play
With Auto Play turned ON (the factory default setting), the VCR automatically starts playback
when you insert a tape with its safety tab removed.
To Access Auto Play:
1. In the PREFERENCES menu, press 2 repeatedly to switch between Auto Play: ON and OFF.
• Select ON if you want a tape with its safety tab removed to start playing automatically
when inserted.
• Select OFF if you do not want a tape with its safety tab removed to start playing
automatically.
Auto TV/VCR
To control whether the VCR’s TV/VCR setting changes automatically to VCR-viewing mode
when turned on, use the Auto TV/VCR setting.
To Access Auto TV/VCR:
1. In the PREFERENCES menu, press 3 to repeatedly to toggle between Auto TV/VCR: ON and
OFF.
Note: Pressing the TV•VCR button on the remote control will switch between VCR and TV-
viewing modes. When in VCR-viewing mode, VCR is displayed on the front panel. The VCR
indicator turns off when in TV-viewing mode.
• Select ON to switch VCR-viewing mode on automatically when the power is turned on.
The VCR must be connected to the TV using the supplied RF coaxial cable.
• Select OFF to remain in the TV-viewing mode when the VCR is initially turned on.
Leaving Auto TV/VCR off is useful if you use A/V cables to connect the VCR to the TV
and you watch the VCR’s picture using the TV’s video line input. This way, the antenna/
cable signal will not be interrupted by the VCR.