Attaching the headset holder, Adjusting the headset – Radio Shack ET-548 User Manual

Page 9

ATTACHING THE HEADSET
HOLDER

Put the headset holder into the slot on the
back of the base and slide it into place.

ADJUSTING THE HEADSET

1. Put on the headset, and adjust the

band until it rests with almost no pres-
sure on your ear and the top of your
head.

If the headset is loose, remove it and
gently push the headset band inward

slightly to tighten it. If the headset is
tight, gently pull the headset band out
to loosen it.

2. Hold the headset in place, and turn

the microphone boom until it is about
2 inches from your mouth.

When you are not using the headset,
place it on the headset holder.

Illustration

43-1048.fm Page 9 Tuesday, August 17, 1999 12:45 PM