Radio Shack ET-548 - Manual (Page 17)

17
If the problem persists, disconnect the phone. If other phones on the same line work
properly, the fault is in this phone or its installation. If you cannot locate the problem,
take your phone to your local RadioShack store for assistance.
The phone does not work. Ensure POWER is set to ON .
Move the remote keypad closer to the base.
Fully extend the base’s antenna and raise it to a vertical
position.
Ensure the phone’s modular cord and the AC adapter
are correctly and securely connected.
Recharge the remote keypad’s battery pack. (If the bat-
tery power is too low, the TALK/LOW BATT. indicator
does not light.)
Reset the security access-protection code by placing
the remote keypad in the cradle with
POWER set to ON ,
disconnect AC power and then reconnect AC power.
SYMPTOM SUGGESTION
43-1048.fm Page 17 Tuesday, August 17, 1999 12:45 PM