Radio Shack ET-548 - Manual (Page 10)

10
SETTING THE DIALING
MODE
Set TONE-PULSE on the side of the base
for the type of service you have. If you are
not sure which type you have, do this sim-
ple test after charging the battery.
1. Set POWER to ON .
2. Set TONE-PULSE to TONE .
3. Lift the remote keypad from the base.
Then press TALK/HANG UP and listen
for a dial tone.
4. Press any number other than 0.
If the dial tone stops, you have touch-
tone service. Leave
TONE-PULSE set
to TONE .
If the dial tone continues, you have
pulse service. Set
TONE-PULSE to
PULSE .
USING THE BELT CLIP
Use the belt clip to hang the remote key-
pad on your belt or waistband for hands-
free carrying.
Illustration
Illustration
43-1048.fm Page 10 Tuesday, August 17, 1999 12:45 PM