beautypg.com

Raypak 336A User Manual

Page 27

background image

27

TRANSFORMER WIRING

120 VAC WIRING
For 120 VAC input power to the unit, connect the black wire to the “L1” or hot leg of the power supply. Connect
the white wire to the “Ret” or neutral leg of the power supply. Attach the wire nut to the red wire. There should
be no connection to the red wire for 120 VAC operation.

For Low NOx pool heaters attach a wire nut to each

red wire independently.

Fig. #9471

240 VAC WIRING
For 240 VAC input power to the unit, connect the black wire to the “L1” or hot leg of the power supply. Connect
the red wire to the “L2” or second hot leg of the power supply. Attach the wire nut to the white wire. There should
be no connection to the white wire for 240 VAC operation.

For Low NOx pool heaters attach a wire nut to

each white wire independently.

Fig. # 9471.1

Heater must be electrically grounded and bonded in accordance with local codes, or, in the absence of local
codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70. (Canada - Canadian Electrical
Code, CSA C22.1, Part 1 and Part 2.)

120V ATMOSPHERIC HEATER

120V LOW NOx HEATER

SUPPLY

SIDE

SUPPLY

SIDE

RETURN

or

NEUTRAL

RETURN

or

NEUTRAL

HEATER

4 WIRES

HEATER

7 WIRES

GROUND

L1

L1

HOT

RED

RED

RED

BLACK

BLACK

BLACK

BLACK

HOT

BLACK

GREEN

GREEN

GREEN

GREEN

WHITE

WHITE

WHITE

WHITE

WHITE

240V ATMOSPHERIC HEATER

240V LOW NOx HEATER

HEATER

4 WIRES

HEATER

7 WIRES

GROUND

L1

L2

L1

L2

RED

RED

BLACK

BLACK

BLACK

HOT

RED

RED

RED

HOT

HOT

BLACK

HOT

BLACK

GREEN

GREEN

GREEN

GREEN

WHITE

WHITE

WHITE

SUPPLY

SIDE

SUPPLY

SIDE

NOTE:

Input power to the heater (120 or 240 VAC) can be supplied from the load (pump) side of time clock or

directly from the GFCI power source. It is preferred to make connection to the load/pump side of the time
clock.

If using the switched GFCI power source, the heater could display false service indicators on the display

panel if the pump is turned off.

NOTE:

If the transformerʼs primary side is wired for 120 VAC and 240 VAC is applied, damage to the transformer

and PC board may result. Such damages are not covered under manufacturerʼs limited warranty.

This manual is related to the following products: