Radio Shack ET-927 - Manual (Page 14)

14
OPERATION
MAKING/ANSWERING
CALLS
To make a call, lift the handset and
press
TALK . When you hear the dial
tone, dial the number.
To answer a call when the handset is on
the base, just lift the handset and begin
your conversation.
To answer a call when the handset is
not on the base, press any key on the
handset before speaking.
Both the IN USE indicator on the base
and the TALK indicator on the handset
flash when you receive a call, and the
TALK indicator lights steadily while the
handset is in use.
To end a call, place the handset on the
base or press
TALK so the TALK indica-
tor on the handset turns off.
Important: If you move the handset out-
side the base’s range (about 550 feet),
the handset will not operate properly
and a call in progress might be discon-
nected (see “Troubleshooting” on
Page 20).
ADJUSTING THE VOLUME
The handset’s VOLUME control lets you
set the volume you hear through the
handset to one of four levels.
To turn the volume up or down during a
call, repeatedly press
VOLUME ▲ or ▼
on the handset. The ET-927 beeps once
each time you press
VOLUME ▲ or ▼ .
When you reach the highest or lowest
volume level, the ET-927 beeps three
times.
USING REDIAL
To redial the last number dialed, press
REDIAL when you hear the dial tone.
illus -- add callout to
TALK indicator
Illus
Illus
43-1097a.fm Page 14 Tuesday, August 31, 1999 10:01 PM