Radio Shack ET-927 - Manual (Page 13)

13
ADJUSTING THE
RINGERS
The ET-927’s handset and base each
have four different ringer tones. You can
set the base’s and handset’s ringer tone,
or turn off the ringer on either or both.
Turning On/Off the Ringers
To have the base ring when a call
comes in, set
RINGER ON/OFF on the
back of the base to ON .
To have it not sound, set RINGER ON/
OFF to OFF .
To have the handset ring when a call
comes in, set
RINGER ON/OFF on the
handset’s left side to ON .
To have it not sound, set RINGER ON/
OFF to OFF.
Note: Even if you turn off the ringer on
the handset or base, you can still make
calls using that keypad, and you can still
answer calls if you hear another phone
on that same line ring (see “Operation”
on Page 14).
Setting the Ringer’s Volume
To adjust the ringer’s volume when the
phone is not in use, repeatedly press
VOLUME ▲ or ▼ on the handset.
Checking/Setting the Ringer
Tone
The base and handset are both preset
to use the same ringer tone (
1 ). To
change or hear the different tones, press
FLASH then 1 , 2 , 3 , or 4 when the phone
is not in use. (The last number button
you pressed is the tone you will hear.)
Illus
location of handset’s
RINGER ON/OFF
set to ON
add illus of FLASH
43-1097a.fm Page 13 Tuesday, August 31, 1999 10:01 PM