Radio Shack PRO-528 - Manual (Page 59)

59
Beyond the Basics
Important: If you are scanning any
system other than a Motorola Type
I system, be sure status bit ignore
is set to ON or you will miss some
transmissions.
Follow these steps to turn status bit ignore
on or off.
1. Set the scanner to conventional
programming mode and then press
TRUNK.
2. Select the bank.
3. Repeatedly press S or T to select
Motorola Type, then press E/PGM.
4. Repeatedly press S or T to select S-
bit, then press E/PGM.
5. Repeatedly press S or T to select ON
or OFF, then press E/PGM.
identifying a trunked frequency
While ID scanning (looking for IDs within
a trunked system) or performing an ID
search, press T to see the current trunked
frequency. (The frequency fl ashes twice.)
Then hold down T until a confi rmation
tone sounds and the ID and the frequency
alternately appear.
To return to normal operation, press T.