Radio Shack PRO-528 - Manual (Page 53)

53
Beyond the Basics
the scanner. If it is set too high, it could
prevent your scanner from locking on the
control channel reliably. If it is set too low,
it will slightly delay fi nding the control
channel. The best setting is the same as
for conventional reception and is critical
for monitoring trunked systems.
programming trunked
frequencies
Follow these steps to select, program, and
store trunked frequencies.
1. Press E/PGM in conventional mode to
set the scanner in programming mode.
Then, press TRUNK. Your scanner
beeps a tone. Then TRUNK and all of
the bank numbers fl ash.
2. Press the number key (1-9 and 0) of
the desired target storage bank. Select
one of the trunk systems by repeatedly
pressing S or T to select a trunking
system type, then press E/PGM.
Note: You can select from the
following six systems:
You See Trunk
System
E2 – 800 Motorola
Type II,
800 MHz
frequencies
Notes