Radio Shack PRO-528 - Manual (Page 38)

38
Beyond the Basics
3. Determine the scanner which has
the frequency data that you want to
transfer and set it to be the FirSt unit.
4. Set the other unit to be the CLONE unit.
5. Press E/PGM on the First Unit and
then CLONE unit. The First Unit checks
whether the CLONE unit is connected
correctly. When a First Unit receives the
response from the CLONE unit, the data
transfer starts. During data transfer,
SND and REC fl ash.
6. When the data transfer is completed,
done appears. If the data transfer is not
successful, Error appears.
7. After the clone operation is complete,
remove the cable, turn both unit off and
then on again.
using the display backlight
To turn on the display light for easy viewing
at night, press
.The display lights for 15
seconds. To turn off the light sooner, press
again.
using the auto backlight
display
You can set the scanner so the auto
backlight turns on for about 5 seconds
when the scanner receives signals.