RIDGID WL1200LS1 - Manual (Page 19)

19
Mounting Rear Foot
1. Locate the following:
1 M8 x 1.25-45 Pan Head Screw
1 M8 x 1.25 Square Nut
1 M6 x 1.0-65 Carriage Bolt
1 6.5 x 19 x 1.6 Flat Washer
1 6mm Lockwasher
1 M6 x 1.0 Hex Nut
2. Install the rear foot onto the tube as
shown and tighten rear foot locking
screw. One corner of the nut will rest in
the trough on the foot, the opposite cor-
ner of the nut will rest against the wall
of the tube. Foot will wedge into place
as screw is tightened. This may take
several attempts.
3. Attach the rear foot on the right side
table board, hole labeled K. Secure in
place with bolt, washer, lockwasher and
nut as shown.
Nut Hex
M6 x 1.0
Carriage Bolt
M6 x 1.0-65
Pan Head Screw
M8 x 1.25-45
Nut Square
M8 x 1.25
Flat Washer
6.5 x 19 x 1.6
Lockwasher
6mm
Tube
Rear Foot
Square
Nut
Pan Head Screw
M8 x 1.25-45
Headstock
Hole K
Carriage Bolt
M6 x 1.0-65
Washer
Lockwasher
Hex Nut
Assembly
End