RIDGID WL1200LS1 User Manual

Page 13

Mounting Right Side Table Top

1. Find the following:

1 Particle Board Table Top

2. From the loose parts package find the

following:

4 M6 x 1.0-45 Carriage Bolts
4 M6 x 1.0 Hex Head Nuts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers

3. The right side mounts similar to the left

except there is no steel support plate.

4. Place carriage bolts, through the table

top holes B and D as shown. Align the
right side table top with the left side
table top so that the two halves join end
to end. Fasten in place with a washer,
lockwasher and nut.

5. Securely tighten all nuts and bolts.
6. Adjust leveling feet as follows:

a. Move legset to desired location.
b. With a 14mm wrench loosen bottom

nut.

c. Back off top nut by hand.
d. Raise or lower foot by adjusting bot-

tom nut using 14mm wrench.

e. Snug top nut against inside of leg by

hand.

f. Tighten all four bottom nuts using

14mm wrench.

Particle Board Table Top

Carriage Bolt

M6 x 1.0-45

Flat Washer

Nut Hex

6.5 x 19 x 1.6

M6 x 1.0

Lockwasher

6mm

Motor Mounting Plate

Left Side

Right Side

Table Top