RCA 2-9680 - Manual (Page 5)

3
1 Plug the telephone line
cord into the base and
into a modular jack.
2 Plug the power supply
cord into the base, and
then the power supply in
an AC outlet.
M
ODULAR
J
ACK
R
EQUIREMENTS
You need an RJ11 type modular jack, which is the most
common type of phone jack and might look like the one
pictured here. If you don’t have a modular jack, call your
local phone company to find out how to get one installed.
PAGE/FIND IN USE CHARGE
1 2 3 4 5 6 7 8 9 0 AREA CODE PHONE NUMBER OR
1
4
7 8
* 0 #
ABC DEF
JKL MNO
TUV
GHI
PRS WXY
OPER
MEMORY FLASH REDIAL
TONE
PAGE/FIND IN USE CHARGE
5 6
9
2 3
PHONE CHANNEL ON/OFF
5 Place handset in the base (facing either
direction) to charge for 12 hours.
The CHARGE/IN USE light comes on
indicating that the battery is charging.
6 Turn on the RINGER switch so the
handset rings for incoming calls.
NOTE: Use only the Thomson 5-2348 power supply that came with this unit.
Using other adapters may damage the unit.
3 Raise the base antenna.
4 Set the PULSE/TONE switch to TONE for Touch-Tone service, or PULSE
for rotary service. If you don’t know which type of service you have,
check with the phone company.
LSE/TONE
PULSE/TONE switch
I
NSTALLATION AND
S
ETUP
RINGER switch CHARGE/IN USE light