RCA 2-9680 - Manual (Page 12)

10
A
PPENDIX
A: H
ANDSET
S
OUND
S
IGNALS
Signal Meaning
Three long beeps Page signal
A long warbling tone (with ringer on) Signals an incoming call
Four short beeps Out of range warning
A
PPENDIX
B: T
ROUBLESHOOTING
G
UIDE
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem Solution
No dial tone • Check installation:
— Is the base power cord connected to a working
outlet?
— Is the Phone in Use light on?
— Is the telephone line cord connected to the base
unit and the wall jack?
• Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 8.
• Did the handset beep when you pressed the phone
button? Did the Phone in Use light come on? The
battery may need to be charged.
• Reset the security code by placing the handset in the
base for about 20 seconds.