RCA RC940 - Manual (Page 9)

9
English
NOTES:
• If the extension unit's indicator light does not turn green in step 2,
press its PROGRAM button again.
• Do not press the PROGRAM button on the extension unit while
its indicator light is flashing. Wait until its indicator light is not
flashing.
• If the base unit is not in program mode when you press the
extension unit's PROGRAM button, the extension unit's indicator
light will flash red for about ten seconds and then turn solid red.
If you still want to program the extension unit, start from step 1
above. If you do not want to program the extension unit, unplug
the extension unit, and plug it back in to restore a solid green
indicator light.
4. When you have finished programming all the extension units, press
the PROGRAM button on the right side of the base unit. This takes
the base unit out of program mode; the base's indicator light turns
green.
Make sure the indicator lights on the extension units are also solid
green.
NOTE: If you forget to press the button on the base unit after you've
finished programming, the base unit will remain in program mode
for five minutes and then return to normal operating mode (its
indicator light returns to solid green).