RCA RC940 - Manual (Page 3)

3
English
FCC Part 68 & Class B Notices
Your Wireless Phone System complies with Part 68 of FCC Rules. You must, upon request,
provide the FCC registration number and the REN to your telephone company. These numbers
are shown on the label on the base unit.
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules.
These limits provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To
eliminate interference you can try one or more of the following corrective measures:
•
Reorient or relocate the receiving antenna
• Increase the distance between the system and the radio or TV
• Use outlets on different electrical circuits for the equipment and the radio or TV
Read the Troubleshooting section of this manual for directions on remedying the problem.
Lightning
Your Wireless Phone Jack System has built-in protection circuits to reduce the risk of damage
from surges in the telephone line. These protection circuits meet or exceed the FCC requirements.
However, lightning striking the telephone or power lines can damage your system. Lightning
damage is not common. Nevertheless, if you live in an area that has severe electrical storms, we
suggest that you unplug the system during storms to reduce the possibility of damage.
Important Notes On Operation
• Do not plug Phone Jacks into power strips or surge protectors.
• Phone Jack Extension does not operate during a power outage.
• Phone Jack System can only be used for single phone line.
• Be sure to plug Base unit (two jacks on side) in first before Extension unit (one jack on side).
• If you cannot get a dial tone, unplug both phone jacks and reset units following the section
titled “Troubleshooting”on page 10.
• It is very important that directions are followed in order. In the event of a problem unplug both
units, remove all cords and start again.
Industry Canada Equipment Notice
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Documents(s). The
Department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by
the supplier. Any repairs or alterations made by the user to this equipment , or equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect
the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
Product Registration
Please register your product online as soon as possible. Registering your product allows us to
contact you if needed.
Product Information
Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach
it here and record the serial and model numbers in case you need them. These numbers are
located on the product.
Model No.: ________________________________________
Purchase Date: ____________________________________
Dealer/Address/Phone: _____________________________