Storing frequencies into channels – Radio Shack PRO-99 User Manual

Page 30

STORING

FREQUENCIES

INTO CHANNELS

1. To begin programming your

scanner, press

FUNC

, and

then

CAR

to change the

channel display mode.

MAN

, a

bank and channel number
appears on the display. You
can select the desired
channel storage bank and
channel using the number
keys and

SCAN

. For example,

Bank 3, Channel 23 is
entered as "323" and

SCAN

2. Use the number keys and

CLEAR

to enter the

frequency (including the
decimal point) you want to
store.

3. If you make a mistake, press

and hold ./

CLEAR

for about 2

seconds to clear the entire
field and start over.

4. Press

ENT

to store the

frequency into the channel.

If you made a mistake in
entering the frequency,

Invalid Freq.

briefly appears

and the scanner beeps when
you press

ENT

. Enter the

frequency again.

If you enter a frequency that
has already been entered
elsewhere in the same bank,
the scanner sounds an error
tone.

Dupl.Freq.

and the

channel number that has
been duplicated displays. If
the dual entry is an error,

NOTES

•

Your scanner
automatically rounds
the entered
frequency to the
nearest valid
frequency. For
example, if you enter
a frequency of
151.53, your scanner
accepts it as
151.5275. Reception
of the frequency will
not be adversely
affected.

•

You may replace any
frequency by
selecting the bank
and channel,
pressing

and

entering the new
frequency.

•

You can clear

programmed

frequency data.

Press 0 then ENT

20-515Change01_04.fm Page 30 Friday, January 16, 2004 1:14 PM