Radio Shack PRO-99 - Manual (Page 24)

24
Load From Pre-Program CAR
Press 1 key ->YES. Other key->
NO
appears.
4. Press 1 to program the race
frequency or other than 1 to
cancel the programming.
S
TORING A
C
AR
N
UMBER
AND F REQUENCY
You can store a car number and
frequency in each of the scanner's
channels, and you can recall any
frequencies associated with the
car number by entering the
number. You can store one car
number in each channel (for up to
500 car numbers).
Ô
1. Repeatedly press CAR until
Input Car#? appears.
2. Enter the car number. If the
number is one or two digits,
enter the number then press
CAR . If the number is three
digits, enter the number only.
P.Fr (Program Frequency),
the car number, and
frequency (or
0.00000 MHz )
appears.
3. Enter the frequency (including
the decimal point) you want to
associate with the car number
by using the number keys and
./
CLEAR.
To clear the display (if you
make a mistake), press and
hold ./
CLEAR before you
press ENT .
4. Press ENT to store the
frequency. The car number
Ô
NOTES
Ô
• After you store a car
number and a
frequency, you can
store additional
frequencies then
associate those
frequencies with the
same car number.
See “Adding
Frequencies To a
Car Number” on
Page 25“
• If you add one or
more leading zeros to
a single digit car
number, your
scanner recognizes
them as different car
numbers. For
example, you can
enter 5 for one car
number, 05 for
another car number,
and 005 for another
car number.
20-515Change01_04.fm Page 24 Friday, January 16, 2004 1:14 PM