Roland RE-20 - Manual (Page 14)

14
Operating the RE-20
Setting the Delay Time with the TAP Pedal
(Tap Delay Time)
1. Using the MODE SELECTOR knob, select the Variation mode for which the tap
delay time is to be set.
* For more on the playback heads for which the tap delay time is set, and the maximum values of the
settings, refer to “About the Variation Mode” (p. 18).
2. Press the TAP pedal two or more times at the tempo you want to set.
This sets the tap delay time. The TAP indicator flashes in sync with the tap delay time.
* Enabled only when the MODE SELECTOR knob is set to any position from 1 through 11.
* When any of the following are carried out, the tap delay time setting changes
REPEAT RATE knob turned ➔ changes to the value set with the REPEAT RATE knob
MODE SELECTOR knob turned ➔ changes to the value set with the REPEAT RATE knob
Repeat rate or twist changed with ➔ changes to the value set with the expression pedal
an expression pedal
* You cannot save the tap delay time setting.
* When the twist effect is applied using the TAP pedal (from when the TAP indicator is off to when it
goes on or starts flashing), you cannot set the tap delay time.
Applying the Twist Effect with the TAP Pedal
The twist effect simultaneously increases the repeat rate and the intensity, causing the
echo sound to oscillate. In addition, the echo volume level is controlled.
* Enabled only when the MODE SELECTOR knob is set to any position from 1 through 11.
1. Press and hold down the TAP pedal.
The TAP indicator goes out, and application of the twist effect begins.
The echo sound begins to oscillate, then the oscillation increases as the pitch rises as well.
* You cannot set the repeat rate and intensity while the TAP pedal is held down.
Blink
Press two or more times
Press and hold down
Off
RE-20_e.book 14 ページ ２００７年６月８日 金曜日 午後４時３２分