RCA RC5400P - Manual (Page 17)

Chapter 1
chapter 1 13
Install the Battery in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new battery. Match the polarities (+ and –) on the battery with the
diagram on the remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you’re not going to use the remote for a month or more, be sure to remove
the battery because they can leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and local
regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if
inserted incorrectly, if all batteries are not replaced at the same time, if
disposed of in fire, or if an attempt is made to charge a battery not intended to
be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or
other personal injury.
Point the Remote in the Right Direction
When you want the remote to operate the DVD Player, point the remote at the
DVD Player, not the TV. The remote has to be pointed in the correct direction and
toward the correct component in order for the remote’s signal to communicate with
the sensor on the component. Make sure there is a clear path between the remote
and the component you want to operate so the signal isn’t blocked.