Regency P42-LP3 - Manual (Page 25)

Regency P42-3 Zero Clearance Direct Vent Gas Fireplace 25
INSTALLATION
Diagram 1
Diagram 3
STANDARD
FLUSH DOOR
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1.
Diagram 2
NOTE: Springs must always be OVER
not under the gas line.
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and the
door lip to ensure that the door sits securely on
the unit. Diagram 2.
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd and 3rd spring. See
diagram 3.
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox. Diagram 1.
2) Attach the 2 bottom louver hinges to the
bottom flange on the firebox using 2 screws
per hinge. Diagram 1.
To remove the flush door, reverse the above
steps.
Note: Top and bottom louvers
are different.
Diagram 1
Diagram 2
3) Attach the bottom louver to the 2 hinges
using 2 screws per hinge. Diagram 2.
DOUBLE SCREEN
DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
flush door.
Clip locations
Clip installed on right side.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.