Renesas MCU Board for PC4400 Emulator System M34282T5-OPT - Manual (Page 13)

( 11 / 38 )
3. Contents of M34282T5-OPT Package
3.1 Package Components of M34282T5-OPT
Table 3.1 shows the package components of the M34282T5-OPT. When unpacking your package,
check to see that all of these components are included.
Table 3.1 Contents of M34282T5-OPT
*1 The M34282T5-OPT has a 4MHz oscillator circuit board OSC-2 that is incorporated when
shipped from the factory. In addition, an oscillator circuit board OSC-2 for 500 kHz and an
oscillator circuit board OSC-2 on which only J1 connector mounted are included.
*2 Keep the packaging carton and cushion material of the M34282T5-OPT to transport it for repair
or for other purposes in the future.
*3 If you find any item missing or faulty, or any suggestion, contact your local distributor.
3.2 Other Necessary Products
To bring forward program development on the 4282 Group of 4-bit MCUs, the products listed in
Table 3.2 are necessary in addition to those contained in the package above. Get them separately to
be ready when necessary.
Table 3.2 Products required for program development on the 4282 Group MCUs
* The serial programmers and PROM programming adapters in Table 3.2 are products of Suisei
Electronics System Co., Ltd. For inquiries about these products, contact Suisei Electronics
System Co., Ltd.
Suisei Electronics System Co., Ltd.
Tsurumi 6-5-24, Tsurumi-ku, Osaka 538-0053, JAPAN
Tel: +81-6-913-4531
Fax: +81-6-913-4534
URL: http://www.suisei.co.jp/index_e.htm
Item
M34282T5-OPT
40-wire half-pitch cable (40 cm)
20-wire normal-pitch cable (10 cm)
2-wire cable for external trigger signal (50 cm)
PCA4029 pitch converter board
Oscillator board OSC-2 (500 kHz)
Oscillator board OSC-2 (only J1 connector mounted)
M34282T5-OPT Instruction manual (this manual)
M34282T5-OPT Instruction Manual (Japanese)
Quantity
1
1
1
1
1
1
1
1
1
Emulator system
PC4000E (emulator main unit)
PC4400 (emulator card cage)
PCA4400A (control board)
PCA4400R (function expansion board)
RTT72
MSP-II
EFP-I (PROM & FLASH programmer main unit)
EF1SRP-01U (unit for serial writing)
Cable for connecting the target (3-line type)
MS4238-20F (for 20P2N-A package)
MS4280-20G (for 20P2E/F-A package)
Emulator debugger
Serial programmer*
PROM programming adapters*
PROM & FLASH programmer*