Installing the head – RIDGID SP6490 User Manual

Page 15

Text mode
Original mode

Installing the Head

CAUTION: The head assembly

weighs about 80 pounds. To reduce

the risk of back injury get help to lift

the head.

1. Locate (2) two 10mm dia. x 12mm long

set screws in loose parts bag.

2. Remove protective bag from head

assembly and discard. Carefully lift head
above column tube and slide it onto col-
umn making sure head slides down over
column as far as possible. Align head
with table and base.

3. Install a set screw in each hole (as indi-

cated) on the right side of the head, and
using a 5mm hex “L” wrench, tighten the
two head lock set screws.

10mm Dia. x 12mm

Set Screw

Head

Column

Head Lock

Set Screws

Head