Information, Signal / system, Field service / manufacturing – Runco VIDEOXTREME VX-8D User Manual

Page 75: Pre l iminar y

Runco VX-8d Installation/Operation Manual

PRE

IMINAR

You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:

• Brightness

• Contrast

• Color saturation

• Tint

• Sharpness

• Gamma

• Lamp Settings

• Color temperature and white balance

To select a memory preset, press

to highlight it and press ENTER.

To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press

to highlight Save and press ENTER.

To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press

to highlight Reset and press ENTER.

Information

Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.

Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.

Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.

To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 62).

Note

Input Source

HDMI 1

Signal Format

1080p/60