RAD Data comm MBE10-1D - Manual (Page 35)

MBE Family Installation and Operation Manual Chapter 2 Installation
Installation and Setup 2-9
Connecting the Power
AC Power
Supply AC power to the MBE unit through the 1.5m (5 ft) standard power cable
terminated by a standard 3-prong plug. The cable is provided with the unit.
A 2A slow-blow fuse is located in the power supply unit.
To prevent electrical fire hazard, always replace the fuse with the same type
and rating as indicated.
➤ To connect AC power to the MBE unit:
1. Connect the power cable to the power connector on the MBE rear panel.
2. Connect the power cable to the mains outlet.
3. Set the POWER switch to ON.
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com