Radio Shack ET-919 - Manual (Page 8)

8
7. Plug the adapter into a standard AC
outlet.
8. Lift the base’s antenna to a vertical
position.
MOUNTING THE BASE ON
A WALL PLATE
1. Remove the bracket by holding in
both tabs and gently pulling out the
wide end of the bracket.
2. Plug one end of the supplied short
modular cord into the phone jack on
the back of the base. Route the
modular cord through the left slot on
the bottom of the base.
3. Insert the supplied AC adapter’s
barrel plug into the DC 12V jack on
the back of the base. Route the
adapter’s cord through the right slot
on the bottom of the base.
4. Route the other end of the short
modular cord through the center of
the bracket.
Phone Jack
DC 12V
Jack
43-1089.fm Page 8 Tuesday, August 17, 1999 3:24 PM