NEC MAGICOLOR 6110 - Manual (Page 184)

Requirements 182
Location Requirements
„
On a hard, flat, level (1.5° or less slant at any point around the
machine) surface capable of supporting the printer, accessories, con-
sumables, and media. Weights are shown below.
5"
A surface can be tested for levelness with a standard round pencil.
If the pencil rolls, the surface is not level. Clear the area of any
obstruction or items such as cables that might prevent the printer
from sitting directly on the flat, level surface.
Noise-generating
Equipment Should not be connected to the same electrical outlet
as the printer.
Recommended Fre-
quency 60 Hz ±2 Hz for a 120 V system, and 50 Hz ±2 Hz for
a 220–240 V system.
Grounding Your printer requires a properly grounded AC outlet.
Power Japan 100 VAC 50–60 Hz 13 amps
North America 120 VAC 50–60 Hz 11 amps
Europe 220–240 VAC 50–60 Hz 6 amps
Latin America 120 VAC 50–60 Hz 11 amps
220–240 VAC 50–60 Hz 6 amps
Voltage
Fluctuation
Rate Japan 100 VAC ±10%
North America 120 VAC ±10%
Europe 220–240 VAC ±10%
Latin America 120 VAC ±10%
220–240 VAC ±10%
Frequency
Variation Rate Within 50–60 ±3 Hz
Component Weight
Printer 101 lbs (46 kg)
Consumables (such as toner,
OPC belt) 11 lbs (5.0 kg) (total)
Media 5.2 lbs (1.9 kg) per ream of 20 lb
bond (75 g/m
2 ) paper
Lower feeder unit (each) 14.8 lbs (6.7 kg)
Duplex unit 5.3 lbs (2.4 kg)