beautypg.com

11 installation: setup and test, Setup and test – Navman 5505 User Manual

Page 59

background image

TRACKER 5505/5505i/5605 Installation and Operation Manual

59

NAVMAN

Setup and test

1 Put a blanking cap on any unused connector

on the back of the display unit. Ensure all
connectors are plugged in and the display
unit is in place.

2 If the display unit is bracket mounted, adjust

tilt and rotation for best viewing and hand
tighten the knob.

3 Insert any required C-MAP chart card (see

section 1-3).

4 Turn the instrument on (see section 2-3).

When the TRACKER is turned on for the first
time, it displays an installation menu:
i

Select the language to use.

ii Change the data if necessary

(see section 2-1)

iii When the setup data is correct, press

.

This data can be changed later
(see section 14).

5 Enter setup data to set up the TRACKER to

your requirements and to set up any optional
sensors or instruments (see section 14).

6 At the satellite display, check that it picks

up GPS satellites. Wait for the GPS receiver
to start up and the fix type to change from
‘Acquiring’ to ‘GPS fix’. This should take less
than two minutes (see section 7).

7 Go on a test run to check that the navigation

equipment works correctly, particularly
when a radio transmitter or radar is used.

15-11 Installation: Setup and test