NEC LT260 - Manual (Page 50)

E-50
Setting the function switch
ON OFF
There are two switches on the bottom of
the battery case: an applicable projector
selector switch (1) and laser enable/dis-
able switch (2). Check the projector be-
ing used and decide whether to enable
or disable laser, then set these switches
as necessary using the tip of a thin ball-
point pen. On this model, an applicable
projector selector switch (1) is not used.
Switch (2)
On: Enabled (the laser lights when the LASER button is pressed)
[Factory default]
Off: Disabled (the laser does not light even when the LASER button
is pressed)
Disable the laser when using in an environment in which the unit is acces-
sible to children.
PROJECTING AN IMAGE