Nikon LS-30 - Manual (Page 5)

- 5 - Safety Precautions
Safety Precautions
Observe the following safety precautions when installing and
operating the LS-30:
• Do not allow your fingers, hair, or clothing into the
film insertion slot
Do not insert your fingers, hair, or clothing into the film
insertion slot on the front of the scanner when the power is
on and a film adapter is in place. Doing so could result in
injury.
• Use an appropriate power supply
Use an AC power supply of 50/60Hz and a voltage of from
100V–240V. Be sure to use a power cord rated for the
appropriate voltage.
At voltages of more than AC 125V:
use a power cord that complies with the safety standards of
the country in which it is used, which has a plug rated for AC
250V, 15A (NEMA 6P-15) and insulation of SVT type or
better, and which is more than AWG18 in thickness.
At voltages of AC 125V or less:
use a power cord that complies with the safety standards of
the country in which it is used, which has a plug rated for AC
125V, 10A and insulation of SVT type or better, and which is
more than AWG18 in thickness.
• Connect the scanner to ground
The outlet into which the power cable is plugged must be
grounded. Failure to ground the power supply could result
in electric shock.
• The scanner and all devices to which it is connected must be
connected to a common ground. If a common ground is not
used, a ground loop could occur, causing electric shock or
noise static.
• Do not ground the outlet to a gas or water pipe.
* The shape of the cable may
vary depending on the country
of sale.