Nikon LS-30 - Manual (Page 43)

- 43 - Maintenance: Transport
Transport
The LS-30 is for use only in the country of sale. Nikon will not
be held responsible for consequences resulting from use over-
seas.
The scanning mechanism must be locked in its home position for
transport within the country. To return the scanning mechanism
to its home position, remove any adapters from the adapter
slot and then turn the scanner on. The status LED will blink
while the scanning mechanism returns to the home position.
Wait until the status LED glows steadily, then turn off and
unplug the scanner. Place the guard in the adapter slot as
shown below, sliding it in until it contacts the back of the slot.
Remove the transport locking screws from the rear panel and
screw them into the holes provided in the side panel and the
mouth of the adapter slot (the hole in the mouth of the slot
should align with the hole in the guard). Close the front cover
and pack the scanner and adapters in the original packing mate-
rial for transport.
✔
Caution: Do not transport the scanner without first locking
the scanning mechanism with the transport lock screws. Moving
the scanner without the lock screws in place could damage the
mechanism.