Nikon LS-30 - Manual (Page 19)

- 19 - Setup: Installation
Once the scanner is installed, slide the front cover open. Using
a coin, remove the transport locking screws from the adapter
slot and side panel and screw them into the holes provided on
the rear panel. The adapter slot contains a plastic guard to
prevent the transport screw from falling into the scan mecha-
nism when the transport screw is removed. After removing the
transport screw from the adapter slot and screwing it into one
of the holes on the rear of the scanner, remove the guard and
store it in a safe place.
✔
Caution: Never turn the scanner on with the locking screws
in place. Turning the power on in these circumstances could
damage the scanner.
Note: Replace the locking screws and guard when transporting
the scanner (see “Maintenance: Transporting the Scanner,”
below).
Transport locking screws
MADE IN JAPAN
100098
SCSI
SCSI
SCSI NB
TERMINATOR OFF
O
N
6 5
4
3 2 1
0
7
100–240V~ 0.3–0.2A 50/60 Hz
Holes for locking screws
Guard
Coin