Nikon LS-30 - Manual (Page 32)

- 32 - Using the Scanner: Using the MA-20 S
LIDE
M
OUNT
A
DAPTER
Using the FH-2 to scan strip-film
The SA-20 S
TRIP
F
ILM
A
DAPTER
is provided to scan 35 mm film in
strips of from two to six frames. The SA-20’s automatic feed
and eject mechanisms however require film that is flat, cut
straight across at the ends, free from adhesive tape and has all
perforations intact (see “Using the SA-20 S
TRIP F ILM A DAPTER ,”
following). Film that cannot be scanned using the SA-20 can be
scanned in the MA-20 using the FH-2 strip-film holder provided
with your scanner. This section details how to insert film in the
FH-2 and scan it using the MA-20.
Step 1—Open the FH-2
Holding the FH-2 with the “Nikon” logo facing upwards, unlatch
the holder by the snaps and flip it open.
Step 2—Place film in the holder
Place a strip of 35 mm film on the lower holder, oriented so
that the frame numbers are not reversed. Align each frame in
the film with an aperture in the lower holder.
Holder snaps
Film strip
Lower holder
Aperture