Nikon LS-30 - Manual (Page 23)

- 23 - Setup: Connecting the SCSI Cable
SCSI devices cannot be connected while the power is on.
Before connecting the scanner to the SCSI chain, be sure that
the computer and all other devices in the chain, including the
scanner, are off. How the scanner should be connected to the
chain depends on whether it is to be located between other
devices or attached at the end of the chain.
When the scanner is the last device in the chain
Set the terminator switch on the rear of the scanner to ON.
TERMINATOR
OFF ON
Connect the SCSI cable to either of the two SCSI connectors
on the rear of the scanner.
MADE IN JAPAN
100098
SCSI
SCSI
SCSI NB
TERMINATOR OFF
O N
6 5
4
3 2 1
0
7
Connect the other end of the cable to the next device in the
chain. If the scanner is the only external device in the chain,
connect the cable to the computer’s SCSI port.
MADE IN JAPAN 1 0 0 0 9 8
S C S I S C S I
SCSI NB TERMINATOR
OFF ON
6 5 4 3 2 1 0 7
100–240V~
0.3–0.2A
50/60 Hz
If there are other external devices in the chain, connect the
scanner to the last of these devices.
Other SCSI device Other SCSI device
MADE IN JAPAN 1 0 0 0 9 8
S C S I S C S I
SCSI NB TERMINATOR
OFF ON 6 5 4 3 2 1 0 7
100–240V~
0.3–0.2A
50/60 Hz
✔
Caution: Do not touch the
connector pins with your fingers or with
metal objects, as this could result in
static electricity damaging one or more
of the devices in the SCSI chain.