beautypg.com

Troubleshooting – Eizo FlexScan L461 User Manual

Page 29

background image

6. TROUBLESHOOTING

29

ENGLISH

6. TROUBLESHOOTING

If a problem persists even after applying the suggested remedies, contact an EIZO
dealer.

No picture problems Æ See No.1 ~ No.2
Imaging problems ÆSee No.3 ~ No.11
Other problemsÆSee No.12 ~ No.16

1. No picture

• Indicator status: Off

• Indicator status: Green

• Indicator status: Yellow

• Indicator status:

Slowly flashing Yellow

2. Following messages

appear. (Error messages
will remain on the screen
for 40 seconds.)

Check that the power cord is correctly connected.
If the problem persists, turn off the monitor power for a
few minutes, then turn it back on and try again.

Check the “Contrast and Brightness” settings.
Minimum settings will cause screen to be blank.
Try pressing a key on the keyboard, or clicking the mouse.
(p.26)
Try pressing the power switch.

These messages appear when the signal is not inputted
correctly, even if the monitor functions properly.

When the image is displayed correctly after a short time,
there is no problem with the monitor.
(Some PCs do not output the signal soon after powering
on.)
Check that the PC is turned ON.
Check that the signal cable is properly connected to the PC
or graphics board.

Use the graphics board’s utility software to change the
frequency setting. (Refer to the manual of the graphics
board.)

Problems

Points to check with possible solutions

•Whenever an error signal

message appears, the
signal frequency will be
displayed in red.
(Example)