Eizo FlexScan L461 - Manual (Page 18)

18
4. ADJUSTMENT
4. ADJUSTMENT
4-1. Screen Adjustment
• Allow the LCD monitor to stabilize for at least 20 minutes before making image
adjustments.
Screen adjustments for the LCD monitor should be used in suppressing screen flickering
and also for adjusting the screen to its proper position. There is only one correct position
for each display mode. When using the analog input, it is also recommended to use the
ScreenManager function when first installing the display or whenever changing the
system. For convenience, an easy set-up Program installed on the utility disk to assist in
the set-up procedure is provided.
When using the digital input, the monitor displays the digital input image correctly based
on its pre-setting data. Please adjust the contrast and brightness as desired with referring
page 21.
1.
Push the Auto adjustment button on the front panel.
The message “Your setting will be lost, if you press again now.” appears and
remains on the screen for 5 seconds. While the message is on the screen, push the
Auto adjustment button again to automatically adjust the clock, phase, screen
position and resolution. If you do not wish to do adjust the screen, do not push the
Auto adjustment button again.
If the appropriate screen can not be made by using the Auto adjustment button,
adjust the screen through the following procedures.
2.
Install the “Screen adjustment program”.
Having read the “readme.txt” file, install and run the “Screen adjustment program”
in the enclosed EIZO LCD utility disk.
Step by step adjustment is provided by the wizard guide.
• If the user’s operating system has no utility disk (e.g. OS/2), we recommend
setting the desktop pattern to that as shown in the diagram below.
Every-other-dot
pattern